Ramsey Winch ATV-3000 - Manual (Page 5)

3. Remove the bolts that hold the end plate to the
motor end housing. Lift off the end plate and
take the nuts and washers out of the mounting
feet. Set aside the gear assemblies and bush-
ing. The input sun and planetary gear carrier
may come out together.
4. Lean the motor end and loosen the motor tie
bolts off the tie bolt nuts. Lean the motor end
back up so that it is sitting upright. Do not let
the motor end cap come apart from the
rest of the motor. Lift the motor end housing
and rotate 90°. Put the tie bolt nuts in the other
set of pockets and carefully lean the motor end
back. Tighten the tie bolts to 45-50 in-lbs.
torque. Do not overtighten.
5. After rotating the motor, the motor end will
appear as shown at right. The motor studs will
be aligned horizontally, and the motor tie bolt
nuts will be in the other set of pockets.
5