Ramsey Winch ATV-3000 - Manual (Page 14)

14
4. Plug Yellow wire from switch into right termi-
nal (terminal above black with yellow stripe
motor lead). Plug Green wire from switch into
left terminal (terminal above black motor
lead).
Finish Installation
1. Confirm that winch clutch is disengaged.
2. Connect negative (-) battery cable to vehicle
battery. Connect Black Battery Lead from
winch to negative (-) vehicle battery terminal.
3. With ignition switch OFF, press Rocker switch
to “OUT”—winch should not operate. If the
winch does operate with the ignition off, con-
firm that proper accessory wire from ignition
was spliced.
4. Spool a few feet of cable out by hand. Engage
winch clutch. Turn ignition switch ON and
press Rocker switch to “OUT”—winch should
spool cable out.
6. If winch does not operate with ignition on,
check wiring to the schematic on page 14.
7. If winch spools cable IN instead of OUT, turn
off ignition and reverse yellow and green
wires on solenoid.
ATV3000 (Rocker Switch) Parts List
ITEM
NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
QTY.
1
1
1
1
1
1
1
1
1
1
1
1
1
1
PART
NO.
251214
251189
251191
251192
251193
251213
251236
251195
251196
251234
257536
299728
299724
257535
DESCRIPTION
MOTOR KIT
MOTOR END GEAR SET KIT
CLUTCH KIT
CABLE DRUM KIT
CABLE & HOOK KIT
CLUTCH END GEAR KIT
ROLLER FAIRLEAD KIT
BUSHING KIT
TIE BAR KIT
SOLENOID KIT
ROCKER SWITCH KIT
SWITCH WIRING KIT
1
SOLENOID WIRING KIT 2
HARDWARE KIT 3
1. Switch Wiring Kit, as shown on facing page,
consists of the following components:
ITEM NO. QTY. DESCRIPTION
12-1 1 123” RED WIRE
12-2 1 123” GREEN WIRE
12-3 1 123” YELLOW WIRE
12-4 1 24” LOOM
2. Solenoid Wiring Kit, as shown on facing
page, consists of the following components:
ITEM NO. QTY. DESCRIPTION
13-1 1 37” MOTOR LEAD - BLACK
W/YELLOW STRIPE
13-2 1 97” BATTERY LEAD - RED
13-3 1 97” BATTERY LEAD - BLACK
13-4 1 37” MOTOR LEAD - BLACK