Ramsey Winch ATV-3000 - Manual (Page 13)

Electrical Schematic (Rocker Switch)
13
SOLENOID ASS’Y.
BLACK W/ YELLOW
STRIPE MOTOR
LEAD
RED
BATTERY LEAD
BLACK
BATTERY LEAD
BATTERY
YELLOW WIRE
BLACK MOTOR
LEAD
GREEN WIRE
RED WIRE
ROCKER SWITCH
#1
MOTOR
#2
NOTE:
TORQUE SOLENOID
TERMINAL NUTS TO
35-40 IN-LBS.
E A
C
B
TO ATV IGNITION
SPLICE
4. Install the Gasket onto the Rocker Switch.
5. Connect Yellow wire (item #12-3) to top ter-
minal on Rocker Switch (terminal behind “IN”
position). Connect Red wire (item #12-1) to
middle terminal on Rocker switch. Connect
Green wire (item #12-2) into bottom terminal
of Rocker switch.
6. Slide Green, Yellow, and Red wires into loom
(item #12-4). Slide loom up to back of the
switch housing.
7. Snap switch and switch housing together.
8. Push Accessory wire from ignition and other
end of Red wire into plastic Splice.
9. Fold splice clip over itself and snap closed.
10. Route wires from Rocker Switch down the
handle bars. Turn the handle bars fully right
and left to ensure plenty of clearance.
11. Make sure wires are not drawn taut across
any surfaces that could damage them. Use
cable ties to anchor wires. Tie off excess.
Connect Wiring to Solenoid (unless motor and
battery leads are switched)
C
AUTION
: T
IGHTEN NUTS ON TERMINAL STUDS TO
35-40
IN
-
LBS
. (3-4 N
M
)
TORQUE
. D
O NOT OVER
-
TIGHTEN
.
1. Connect Red Battery Lead (Item #13-2)
between “A” terminal on Solenoid and positive
(+) vehicle battery terminal.
2. Connect Black Motor Lead (item #13-4)
between #2 terminal on motor and C termi-
nal on solenoid. Connect Black w/Yellow
Stripe Motor Lead (item #13-1) between #1
terminal on motor and B terminal on solenoid.
3. Connect Black Battery Lead (item #13-3) to
“E” terminal on Solenoid and route to nega-
tive (-) vehicle battery terminal but do not
connect.
IN
OUT
For certain mounting applications, where the solenoid needs to
be mounted at the rear of the vehicle, switch the battery and
motor leads. In this case, connect the black w/yellow stripe
lead to the positive (+) terminal of the battery, and the longer
black lead to the negative (-) terminal. Connect the red lead
and the shorter black lead to the motor terminals.