Ramsey Winch ATV-3000 - Manual (Page 4)

Rotating the Motor on your ATV
Winch
The ATV winch has the motor studs and leads
positioned on the end of the motor aligned verti-
cally. If you need to rotate the motor on your ATV
winch to gain clearance, you can rotate the motor
90°. The motor studs will then be aligned horizon-
tally.
Before you begin:
Note: If you have installed the optional Brake kit
(P/N 256116) for the ATV winch, make sure you
have the Brake kit installation instructions before
proceeding. You will need to re-install the Brake
kit after you rotate the motor (step 6 on the fol-
lowing pages). Contact Ramsey if you do not
have your installation instructions.
1. Remove the cable from the drum. Turn the
clutch handle to Freespool and pull cable off.
Slide the end of the cable out of the pocket
next to the drum flange until the cable anchor
can be removed. Be sure to keep the cable
anchor for re-installing the cable. Leave the
clutch set to Freespool.
2. Disconnect the motor leads.
3. Remove the winch from its mounting channel.
Place it on a sturdy, level workbench.
Set the winch down on the clutch end.
1. Remove the tie bar bolts and nuts. Pull tie bars
from between end bearings.
2. Lift the motor end off the drum and set down
with the motor end down. Make sure the shaft,
drum bushing and spring stay with the drum.
4