IEI Integration AFL-LX-Series v2.10 - Manual (Page 65)

AFOLUX LX Series Flat Panel PC
Page 65
Figure 4-13: DDR SO-DIMM Module Installation
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
The motherboard comes with two jumpers. They are listed below.
COM3 pin-9 signal select (JP3)
COM1 and COM2 pin-9 signal select (JP4)
COM2 Mode Select Jumper Settings (JP5)
COM2 Mode Select Jumper Settings (JP6)
Jumper