IEI Integration AFL-LX-Series v2.10 - Manual (Page 40)

AFOLUX LX Series Flat Panel PC
Page 40
3.6 HDD Installation (AF-12A-LX Only)
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To install the HDD into the AF-12A-LX, please follow the steps below:
Step 1: Remove the plastic back cover. See Section
4
3.5 above.
Step 2: Remove the eight retention screws securing the internal aluminum cover
(
4
Figure 3-5 ).
Figure 3-5: AFL-12A-LX Aluminum Back Cover Retention Screws
Step 3: Remove the four hexagonal pillars on the bottom panel.
Figure 3-6: Four Hexagonal Pillars on the Bottom Panel
Step 4: Push the external interface connector apart from the aluminum cover and lift the
aluminum cover off the AFL-12A-LX.