IEI Integration TANK-820-H61 v1.00 - Manual (Page 41)

TANK-820 Em b e d d e d S ys te m
P a g e 28
3.7.5 Dig ita l In p u t/Ou tp u t Co n n e c to r
The digital I/O connector provides programmable input and output for external devices.
The pinouts for the digital I/O connector are listed in the table below.
Figure 3-14: DIO Connector
3.7.6 DVI Co n n e c to r
The TANK-820 has one female DVI-I connector on the front panel. The DVI connectors
are connected to digital display devices. To connect a digital display device to the
TANK-820, please follow the instructions below.
S te p 1: Locate the DVI connector. The location of the DVI connector is shown in
Chapter 1.
S te p 2: Align the DVI connector. Align the male DVI connector on the digital display
device cable with the female DVI connector on the external peripheral interface.
S te p 3: Insert the DVI connector. Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the TANK-820. See Figure 3-15.