IEI Integration uIBX-200 v1.10 - Manual (Page 62)

UIBX-200-R11/Z510P Embedded System
Page 52
ƒ USB Mass Storage Reset Delay [20 Sec]
Use the USB Mass Storage Reset Delay option to set the number of seconds POST
waits for the USB mass storage device after the start unit command.
Î
10 Sec POST waits 10 seconds for the USB mass storage
device after the start unit command.
Î
20 Sec D EFAULT
POST waits 20 seconds for the USB mass storage
device after the start unit command.
Î
30 Sec POST waits 30 seconds for the USB mass storage
device after the start unit command.
Î
40 Sec POST waits 40 seconds for the USB mass storage
device after the start unit command.
ƒ Device ##
The Device## field lists the USB devices that are connected to the system.
ƒ Emulation Type [Auto]
Use the Emulation Type BIOS option to specify the type of emulation BIOS has to
provide for the USB device.
Î
Auto D EFAULT
BIOS auto-detects the current USB.
Î
Floppy
The USB device will be emulated as a floppy drive.
The device can be either A: or B: responding to
INT13h calls that return DL = 0 or DL = 1
respectively.
Î
Forced FDD Allows a hard disk image to be connected as a
floppy image. This option works only for drives
formatted with FAT12, FAT16 or FAT32.
Î
Hard Disk
Allows the USB device to be emulated as hard disk
responding to INT13h calls that return DL values of
80h or above.