IEI Integration PICOe-PV-D4251_N4551_D5251 v1.11 - Manual (Page 68)

PICOe-PV-D4251/N4551/D5251 User Manual
Page 54
4.7.2 Audio Kit Installation
NOTE:
This is an optional item that must be ordered separately. For further
information please contact the nearest
PICOe-PV-D4251/N4551/D5251 distributor, reseller or vendor or
contact an iEi sales representative directly. Send any queries to
[email protected] .
The optional 7.1 channel audio kit connects to the 10-pin audio connector on the
PICOe-PV-D4251/N4551/D5251. The audio kit consists of five audio jacks. One audio
jack, Mic In, connects to a microphone. The remaining four audio jacks, Line-In, Front-Out,
Rear-Out, and Center Subwoofer, connect to speakers. To install the audio kit, please
refer to the steps below:
Step 1: Connect the audio kit cable. The audio kit is shipped with a cable that
connects the audio kit to the PICOe-PV-D4251/N4551/D5251. Connect the
cable to the connector on the back of the audio kit. Make sure the pins are
properly aligned (i.e. pin 1 connects to pin 1).
Step 2: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 3: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
cable connector. Pin 1 on the audio kit cable connector is indicated with a white
dot. See Figure 4-11.