ZOLL R Series Monitor Defibrillator Rev D - Manual (Page 17)

SpO2 Accessories
9650-0901-01 Rev. D R Series Pulse Oximetry (SpO
2
) 15
appear after the unit is powered-up. See the R Series Configuration Guide for instructions on
changing power-up defaults.
SpO
2
Accessories
The following table describes each of the SpO
2
accessories.
Messages and Troubleshooting
Parameter Factory Default Setting Possible Values
Averaging period 8 seconds
• 4 seconds
• 8 seconds
• 16 seconds
Sensitivity level Normal
• Normal
• High
SpO
2
low saturation limit 85% 50% to 100% or OFF
SpO
2
high saturation limit OFF (appears as: ---) 50% to 100% or OFF
Low Heart Rate Alarm Limit 30 beats per minute 20 to 100 beats per minute
High Heart Rate Alarm Limit 150 beats per minute 60 to 280 beats per minute (ECG)
60 to 235 beats per minute (SpO
2
)
Item Description REF
LNCS Adtx Single use sensor for Adult patients > 30 kg 8000-0320
LNCS Pdtx Single use sensor for Pediatrics and Slender Adults 10 - 50 kg 8000-0321
LNCS Inf-L Single use sensor for Infants 3 - 20 kg 8000-0322
LNCS Neo-L Single use sensor for Neonates < 3 kg 8000-0323
LNCS NeoPt-L Single use sensor for Neonates < 1 kg (Pre-term) 8000-0324
LNCS DCI Reusable sensor for Adults and Pediatrics > 30 kg 8000-0294
LNCS DCIP Reusable sensor for Pediatrics 10 - 50 kg 8000-0295
LNC-4 4' Reusable Patient Cable 8000-0298
LNC-10 10’ Reusable Patient Cable 8000-0293
LNC Ext LNC Extension Cable, DB-9 Termination, 4ft 8000-0325
LNCS-to-LNOP Adapter Cable, LNCS Sensor to LNOP Patient Cable 8000-0327
LNOP DC-12 LNOP Adult Reusable Direct Connect 12’ Cable 8000-0296
Message or Symptom Possible Causes Recommended Action
SPO2 AMBIENT LIGHT Excessive ambient light Relocate the sensor, reduce
the ambient light, or shield the
sensor from the light.
SPO2 PULSE SEARCH Sensor cannot detect a pulse. Normal behavior immediately
after applying the sensor. If this
message persists beyond 10
seconds, reposition or relocate
the sensor, or increase
perfusion.