ZOLL M Series Defibrillator Rev B Non-Int 12 Lead User Manual
Page 15
Non-Interpretive 12-lead
9650-0218-01 Non-Interpretive
12-lead
-
13
4. “FAX BUSY” message is displayed.
Receiving phone line is being used. The M Series automatically
re-transmits until the transmission is successful or the M Series
operator presses the Abort softkey.
5. “FAX ERROR” message is
displayed.
A dialing problem other than a busy line, no carrier, or no
connection occurred.
The M Series automatically re-transmits until the transmission is
successful or the M Series operator presses the Abort softkey.
6. “FAX HANGUP” message is
displayed.
Receiving phone is not receiving transmission. The M Series
automatically re-transmits until the transmission is successful or
the M Series operator presses the Abort softkey.
7. “FAX INTERRUPTED” message is
displayed.
1. Power
cycle
M Series unit and retry transmission.
2. Contact ZOLL Technical Service Department.
8. “FAX NO CARRIER” message is
displayed.
Receiving phone line is not picking up or the sending modem is
experiencing problems. The M Series automatically re-
transmits until the transmission is successful or the M Series
operator presses the Abort softkey.
If retransmissions fail:
1. Check modem connection (card and extension cable) to M
Series.
2. Power cycle cellular phone.
9. “FAX NO DIAL TONE” message is
displayed.
1. Check modem connection (card and extension cable) to M
Series.
2. Check modem connection to phone jack or cellular phone.
3. Power cycle cellular phone.
10. “MODEM REQUIRED”
message is displayed.
No PCMCIA modem card present. Insert PCMCIA modem card
in upper slot and repeat transmission.