WARN WIRELESS CONTROL SYSTEM 90287 - Manual

FCC and IndustryCanada(IC) Warning:
• This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
• The term “IC:” before the radio certification number only signifies that
industry Canada technical specifications were met.
• Any changes or modifications to this product not expressly approved by
WARN Industries could void the user’s authority to operate this product.
1
As you read these instructions, you will see
WARNINGS, CAUTIONS, NOTICES and NOTES.
Each message has a specific purpose. WARNINGS are
safety messages that indicate a potentially hazardous
situation, which, if not avoided could result in serious
injury or death. CAUTIONS are safety messages that
indicate a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. A
CAUTION may also be used to alert against unsafe
practice. CAUTIONS and WARNINGS identify the
hazard, indicate how to avoid hazard, and advise of
the probable consequence of not avoiding the hazard.
NOTICES are messages to avoid property damage.
NOTES are additional information to help you complete
a procedure. PLEASE WORK SAFELY!
GENERAL SAFETY PRECAUTIONS
W A R N I N G
W A R N I N G
W A R N I N G
FALLING OR CRUSHING HAZARD
Failure to observe these instructions
could lead to severe injury or death.
• Never operate winch with less than 5
wraps of rope around the drum. Rope could
come loose from the drum, as the rope
attachment to the drum is not designed to
hold a load.
• Never use as an overhead hoist, or to
suspend a load.
• Never use to lift or move persons.
MOVING PARTS ENTANGLEMENT HAZARD
Failure to observe these instructions could
lead to severe injury or death.
To avoid injury to hands or fi ngers.
• Always keep hands clear of rope, hook loop, hook and
fairlead opening during installation, operation, and
when spooling
in or out.
• Always use extreme caution when handling hook and
rope during spooling
operations.
• Always use supplied hook strap whenever spooling
rope in or out, during
installation and during operation.
• Always keep vehicle in sight during winching
operation.
• Always wear heavy leather gloves when handling rope.
CHEMICAL AND FIRE HAZARD
Failure to observe these instructions
could lead to severe injury or death.
• Always remove jewelry and wear eye
protection.
• Never lean over battery while making
connections.
• Always verify area is clear of fuel lines,
fuel tank, brake lines, electrical wires, etc.
when drilling.
• Never route electrical cables:
- Across any sharp edges.
- Through or near moving parts.
- Near parts that become hot.
• Always insulate and protect all exposed
wiring and electrical terminals.
• Always install terminal boots as directed
in installation instructions.