WARN ZEON 10-S Multi-Mount User Manual

Installation instructions, Zeon multi-mount synthetic winch kit

987960A0

WARN INDUSTRIES, INC. 12900 S.E. Capps Road,

Clackamas, OR USA 97015-8903, 1-503-722-1200, FAX: 1-503-722-3000

Customer Service: 1-800-543-9276

Dealer Locator Service: 1-800-910-1122

International Fax: 1-503-722-3005

G E N E R A L S A F E T Y P R E C A U T I O N S

W A R N I N G

Your safety, and the safety of others, is very important. To help you make informed decisions about safety, we have

provided installation and operating instructions and other information on labels and in this guide. This information

alerts you to potential hazards that could hurt you or others. It is not possible to warn you about all potential hazards

associated with this product, you must use your own good judgment.

CARELESS INSTALLATION AND OPERATION CAN RESULT IN SERIOUS INJURY OR EQUIPMENT DAMAGE. READ AND

UNDERSTAND ALL SAFETY PRECAUTIONS AND OPERATING INSTRUCTIONS BEFORE INSTALLING AND OPERATING THIS

PRODUCT.

This guide identifies potential hazards and has important safety messages that help you and others avoid personal injury

or death. WARNING and CAUTION are signal words that identify the level of hazard. These signal words mean:

WARNING signals a hazard that could cause serious injury or death, if you do not follow recommendations. CAUTION

signals a hazard that may cause minor to moderate injury, if you do not follow recommendations.

This guide uses NOTICE to call attention to important mechanical information, and Note: to emphasize general

information worthy of special attention.

Impact and Moving Parts Entanglement Hazard

FAILURE TO OBSERVE THESE INSTRUCTIONS COULD LEAD TO SEVERE INJURY OR DEATH

• Always use extreme caution when drilling on any vehicle. Make sure that all fuel lines, brake lines, electrical wires, and other objects are not

punctured or damaged when / if drilling on the vehicle. Thoroughly inspect the area to be drilled (on both sides of material) prior to drilling, and

relocate any objects that may be damaged. Failure to inspect the area to be drilled may result in vehicle damage, electrical shock, fire or personal

injury.

• Always wear safety glasses when installing this kit. A drilling operation will cause flying metal chips. Flying chips can cause eye injury.
• Always use extreme caution when cutting and trimming during fitting.
• Always remove jewelry and wear eye protection.
• Never lean over battery while making connections.
• Never route electrical cables:

• Across any sharp edges.
• Through or near moving parts.
• Near parts that become hot.

• Always insulate and protect all exposed wiring and electrical terminals.
• Always install terminal boots as directed in installation instructions.
• Always use appropriate and adequate care in lifting components into place.
• Always insure components will remain secure during installation and operation.
• Always tighten all nuts and bolts securely, per the installation and operation.
• Always perform regular inspections and maintenance on the winch, winch mount and related hardware.
• Never ever operate this WARN product with damaged or missing parts.

Read installation and operating instructions thoroughly.

INSTALLATION INSTRUCTIONS

ZEON MULTI-MOUNT SYNTHETIC WINCH KIT