WARN PullzAll SERVICE GUIDE 685005, 685006 & 685007 - Manual (Page 44)

986767A2.doc Page 44 of 45
1.3 Motor running but
not pulling
Damaged Geartrain
Replace PullzAll
1.4 Motor does not run.
Check Battery Condition
visually (any short circuit )
Check Battery condition
Faulty Trigger Switch
Defective Motor
Check Wiring condition
Repair or replace it with new
Repair or replace Switch
Replace Motor
1.6 Electrical sparks
appear around
Motor.
Loose connection of Wires to
Motor Terminals.
Secure the Motor Terminal and
Wires to the Terminal.
1.7 Wire harness
insulation has melted
Switch held in power in
position while PullzAll is
stalled.
Replace Wire harness PullzAll
Motor.
Poor installation caused Wire
insulation to be rubbed off or
cut, causing direct short.
Replace Wire harness.
1.8 PullzAll makes
squeaking / high
pitch noise.
Drum Bushing not lubricated.
Grease Drum Bushings.
1.10 Malfunctioning
Not operating correctly.
Cease operation. Diagnose,
Repair or Replace.
1.11 Rapid discharge of
Battery
Check for Power Switch Left
on during storage.
Check for Terminals
corrosion
Defects in charging system
such as faulty Regulator,
loose Terminals, etc...
Damaged Wiring.
Always turn unit off when not in
use.
Clean and service
Check charging system
Check Electrical Circuits