WARN PullzAll SERVICE GUIDE 685005, 685006 & 685007 - Manual (Page 16)

986767A2.doc Page 16 of 45
2.4 MOTOR
2.4.1 REMOVAL OF MOTOR
Before removing the Motor follow the below instructions:
1. Remove the Motor Assembly from the
End Housing by removing the 2 screws
(M5 x .8 x 12), Qty 2 from the casting
securing the Motor using a 4mm Allen
Wrench.
2. Tap the motor with hammer to remove
the Motor Assembly remove from the
Chassis assembly.
3. After removal of the Motor assembly
from the Chassis, keep the Motor
assembly on the work bench.