WansView NCH 537MW - Manual (Page 15)

http://www.wansview.com
15
to the domain name with colon. Example: http://mydomain.dyndns.org:81 .
3.4. Alarm setting
3.4.1. External Alarm Input
Figure 16
The camera should have external alarm input port for enable this functions. Connect external alarm
detector to the input port, the detector will output switching signal when it detects any abnormal, input
port of the camera will detect the level change, so it will detect the alarm, therefore the detector should
be switching sensor (same as switch)
3.4.2. Motion Detection Setting
Figure 17
Please click “apply” after settings are done, and motion detection takes effect. The higher value, the
higher sensitivity. The camera will trigger corresponding alarm when the detection area occur any
change.
3.4.3. Alarm mode setting
After camera triggers the alarm, it will store the capture pictures and videos according to your setting