Vestil MTC-RB - Manual (Page 7)

- 8 -
Step 5 Fasten the back jack plate (#8) onto the vertical supports (#5)
using #14 bolts and 7/16-14 nylock nuts (Fig. 5). Make sure jack
center support (#9) aligns with the slot on back jack plate. Twist #16
nylock nuts onto the ends of the #15 bolts to secure the jack in place.
Step 6 Connect the compactor plate (#13) to the end of the jack with
the carriage bolts (#17) along with 7/16-14 nylock nuts with
warning labels facing the jack (Fig. 6). Place 7/16-14 x 1 ¼”
bolts into correct holes for drum stop (Fig. 7). The inside holes
are for 30 gallon drums, and the outside holes are for 55gallon
drums.
Fig. 5: Assembly Step 5
Fig. 6: Assembly Step 6
Fig. 7: Assembly Step 7
Step 7 Store the compactor with the handle in an upright position. To secure
the handle, insert the clevis pin (#11) into hole when unit is not in use.
Lock the pin in place with the hitch pin clip (F#12) (Fig. 7).
Step 8 MTC-RB ONLY: Place Ø 1/4 - 20 UNC X 3/4
bolts and 1/4in. lock washers through vertical
support holes (Fig. 8).
Fig. 8: Assembly Step 8
Step 9 MTC-RB ONLY: Insert #15 bolt through the
bottom hole on either vertical support weldment,
and through the hole on the roll-out tray when
moving unit (Fig. 8).