Vestil MTC-RB - Manual (Page 6)

A SSEMBLY I NSTRUCTIONS :
The numbers in parentheses correspond to item numbers from the “Parts List” on p. 5.
Step 1 Fasten wheels (#2) in the brackets using ¼-20 x 1 ½” bolts (#4) and ¼-20 nylock nuts (#3). Bolt the
vertical supports (#5) onto the base (#1) using 7/16-14 x 1 ¼” bolts (#14) and 7/16-14 nylock nuts (#16)
(Fig. 1).
Step 2 As shown in Fig. 2, fasten the front jack plate (#6) onto vertical supports (#5) using #14 bolts and #16
nylock nuts. Labels must face outward to be visible to operators.
Step 3 Lay the partially assembled unit on its side as depicted in Fig. 3, and then insert #15 bolts through the
holes in the jack plate. Slide a short jack spacer (#10) over the top bolt. Press the jack center support
(#9) into the appropriate slot.
Step 4 [NOTE: Press the handle against the jack mast in order to properly connect the jack to the frame.] Guide
the installed #15 bolts through the corresponding openings in the jack, as shown in Fig. 4; then slide the
remaining #10 spacer onto the top bolt and the long jack spacer (#18) onto the other bolt. If correctly
installed, the top bolt will project through the holes in the jack handle as well as the holes in the upper
jack slide as shown in the enlarged view in Fig. 4.
- 7 -
Fig. 4: Assembly Step 4 Fig. 3: Assembly Step 3
Fig. 2: Assembly Step 2 Fig. 1: Assembly Step 1