Vestil GLT-4000 - Manual

1
Vestil Manufacturing Corporation
2999 North Wayne St., Angola, IN 46703
Phone (260) 665-7586 • Fax (260) 665-1339
E-mail: [email protected] • www.vestil.com
Contents
Warnings and Safety Instructions ..................... 1
Receiving Instructions ....................................... 1
Loading Instructions .......................................... 2
Operating Instructions ....................................... 2
Installation Instructions ...................................... 2
Periodic Maintenance Instructions .................... 3
Electric Schematic ............................................. 7
Power Conversion ......................................... 8-9
Hydraulic Operation and Schematic .............. 7-8
Exploded Parts Drawing .................................... 9
Parts Identification ........................................... 10
Trouble Shooting Guide ............................ 11-12
Warning Label Identification ............................ 13
Material Safety Data Sheets ..................... 14-15
Warranty .......................................................... 16
Service Record ................................................ 16
Revised 09-01
A company dedicated to solving ergonomic and material handling
problems since 1953.
OWNER'S
MANUAL
GROUND LIFT TILTER
MODEL GLT-4000
WARNINGS & SAFETY INSTRUCTIONS
Read owner's manual completely before operating unit!
• Not a personnel lift.
• Never go under platform if there is weight on unit.
• Remove weight & disconnect power before working on
unit.
• Use only maintenance parts supplied or approved by the
manufacturer.
• Do not change pressure relief valve setting.
• Do not clamp hydraulic cylinder in a vise as you may
distort the barrel.
• Never operate the lift unless you are watching it.
• Load the lift as uniformly as possible.
• Consult the factory for uneven loading.
• Do not continue to operate the UP control if unit is not
raising.
• Relieve system pressure by operating the DOWN
control after the unit has come to rest.
• Consult factory if adding or performing any
modification to the original equipment.
• Do not use brake fluids or jack oils. Use AW 32
Hydraulic oil or equal.
• Make sure all operator safety labels ( see p. 16) and
guards are in place.
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior
to shipment. However, it is possible that the unit may incur
damage during transit. If you see damage when unloading
make a note of it on the SHIPPER RECEIVER.
Ground Lift Tilter
Model GLT-4000
Remove all packing and strapping material,
inspect for damage. IF DAMAGE IS EVIDENT, FILE A
CLAIM WITH THE CARRIER IMMEDIATLY! Also, check
the unit size, type of power unit, etc., to ensure the unit is
correct for the intended application.
SERIAL NUMBER AND CAPACITY
The serial number and capacity are inscribed on the
nameplate ( See p. 16 for location). Please remember to
include these numbers in any correspondence with your
dealer or the factory.