Din-rail mounting, Mounting dimensions – TREND EDS-205 User Manual

Page 5

Text mode
Original mode

— 3 —

Mounting Dimensions

DIN-Rail Mounting

The plastic DIN-Rail attachment plate should already be fixed to the
rear panel of EDS when you take it out of the box. If you need to
reattach the DIN-Rail attachment plate to EDS, make sure the DIN-Rail
kit is situated towards the top, as shown in the figures below

STEP 1:
Insert the top of the DIN-Rail into
the slot.

STEP 2:
The DIN-Rail attachment unit will
snap into place as shown below.

To remove MOXA EDS-205 from
the DIN-Rail, insert a flat-blade
screw driver horizontally into the
DIN-Rail kit under the EDS-205,
and then pull it upwards and
release EDS towards you away
from the DIN-Rail.