Qphy-10gbase-t rl variables, Fixture de-embedding calibration file a, Fixture de-embedding calibration file b – Teledyne LeCroy QPHY-10GBase-T User Manual
Page 30: Fixture de-embedding calibration file c, Fixture de-embedding calibration file d, Pairs to test, Qphy-10gbase-t rl limit sets
QPHY-10GBASE-T RL Variables
F
IXTURE
D
E
-E
MBEDDING
C
ALIBRATION
F
ILE
A
Specify the full path that points to the L12T file used for de-embedding the fixture Pair A with the
second tier calibration method.
F
IXTURE
D
E
-E
MBEDDING
C
ALIBRATION
F
ILE
B
Specify the full path that points to the L12T file used for de-embedding the fixture Pair B with the
second tier calibration method.
F
IXTURE
D
E
-E
MBEDDING
C
ALIBRATION
F
ILE
C
Specify the full path that points to the L12T file used for de-embedding the fixture Pair C with the
second tier calibration method.
F
IXTURE
D
E
-E
MBEDDING
C
ALIBRATION
F
ILE
D
Specify the full path that points to the L12T file used for de-embedding the fixture Pair D with the
second tier calibration method.
P
AIRS
T
O
T
EST
Specify whether to test a single pair (A, B, C or D), or all pairs.
QPHY-10GBASE-T RL Limit Sets
The default installation of QPHY-10GBASE-T RL contains only one limit set, called “Default.” In
this script, limits are only used to convey Unit labels. The actual limits for each value tested are
encoded in or computed by the script and cannot be changed. The default limits used by QPHY-
10GBASE-T are specified in 802.3-2008.
26
923663 Rev A