Teledyne LeCroy QPHY-10GBase-T - Manual (Page 10)

General Setup
The first sub-dialog contains general system settings. These remain in effect for each session,
regardless of Standard, until changed.
Connection tab
Shows IP Address of the test oscilloscope (local host 127.0.0.1 if QualiPHY is run from the
oscilloscope). The Scope Selector allows you to choose the oscilloscope used for testing when
several are connected to the QualiPHY installation. See
Set Up Remote Control for details.
Session Info tab
Optional information about the test session that may be added to reports, such as: Operator
Name, Device Under Test (DUT), Temperature (in
°C) of the test location, and any additional
Comments. There is also an option to Append Results or Replace Results when continuing a
previous session.
To optimize report generation, enter at least a DUT name at the beginning of each session.
Report tab
Settings related to automatic report generation. Choose:
• Reporting behavior of:
o “Ask to generate a report after tests,” where you’ll be prompted to create a new
file for each set of test results.
o “Never generate a report after tests,” where you’ll need to manually execute the
Report Generator to create a report.
o “Always generate a report after tests,” to autogenerate a report of the latest test
results.
• Default report output type of XML, HTML, or PDF.
• A generic Output file name, including the full path to the report output folder.
• Optionally, check Allow style sheet selection in Report Generator to enable the use
of a custom .xslt when generating reports. The path to the .xslt is entered on the Report
Generator dialog.
Report Generator launches the Report Generator dialog, which contains the same settings as
the Report tab, only applied to individual reports.
Advanced tab
This tab launches the X-Replay Mode dialog. See X-Replay Mode .
About tab
Information about your QualiPHY installation.
6 923663 Rev A