Teledyne LeCroy JitKit - Manual (Page 6)

JITKIT Software
Setting up JITKIT
1. Access the JITKIT dialogs by choosing Analysis → Jitter Kit.
The main dialog (Jitter Kit) shows the basic flow of the jitter analysis through a simple block diagram
progressing from left to right. Each block in the diagram is also a button. Touching any of the buttons
opens its corresponding dialog.
2. Check the Enable checkbox. Clearing this box turns off all trace and parameter displays, however, the
setup remains in effect.
3. Touch the Source Setup button to configure your signal input sources, crossing levels, and signal
type.
4. Touch the Gating button to configure gate types, such as by Division, by Number of measurements
and using Waveform gate types.
5. Touch the Measure button to select and configure up to 8 measurement parameters. Place a check-
mark in the Show Table box to display statistics below the grid
6. Touch the Plot button to configure the Jitter Kit display to show different domain views of the jitter
measurements for a single jitter measurement parameter at a time.
7. Touch the Quick View button to quickly set up the four views of jitter and several common jitter
parameters.
The following topics explain each of these steps and options in more detail.
4 922810 Rev A