Teledyne LeCroy JitKit - Manual (Page 10)

JITKIT Software
4. Touch the Input button to select an input from the Select Source dialog.
5. Touch the Use Level Type to choose a level type from the pop-up menu (Absolute, Percent, etc.).
For example, if you want to set an absolute crossing level, touch inside the Use Level Type field and
choose Absolute from the pop-up menu. Then, touch inside the Abs Level data entry field and enter
the voltage level at which the signal timing is measured.
OR
If you want to use a relative level set to the selected percentage on each acquisition, touch inside the
Use Level Type field and choose Percent from the pop-up menu. Then, you can use the quick
buttons below to select commonly used percentage levels, for example, if you selected the Percent
level type, you can touch one of the Set to xx% buttons to quickly set the levels, or touch the High,
Mid and Low buttons to set them to a custom value.
6. Touch inside the Slope data entry control and choose the direction of the voltage transition (Positive
or Negative).
8 922810 Rev A