Teledyne LeCroy PMC2PCI-64 - Manual (Page 11)

10
SPECIFICATIONS: PCI532 & PCI332
Bus: PCI-532, 32-bit PCI, 5V and universal.
PCI-332, 32-bit PCI, 3V and universal.
Voltages:
Inputs From PC bus or the external input, configurable by jumpers per voltage.
Input Requirement 5V @ 20 mA, +/- 12V @ 50 mA
Output Ratings +5V, Jumper selectable to 5 Amp or 1 Amp limit, higher than 5 Amp
current limit can be accommodated per user request.
+3.3V, +VIO and +/- 12V at 1 Amp.
Drop Across the Switches 40 millivolts drop for every 1 Amp drawn for +5V, +3.3V and +VIO
30 millivolts drop for every 1 Amp drawn for -12V.
30 millivolts drop for every 100 milliampere drawn for +12V
Propagation Delay: Less than 500 pico-seconds from the PC bus to the UUT.
The switch propagation delay is rated at only 250 pico-seconds.
Controls:
On-Off SPST switch on-board or the external logic input (system parallel port).
Bus Signals Bus signals can be turned on all at once or selectively groups of 10 via the
dip switch or an external I/O control.
Outputs:
J3 +5V current draw by the UUT can be measured at a two-point terminal, J3,
by a voltmeter. Each volt represents 1 Amp.
JP1 JP1-1 to JP1-59, all odd pins on the B side, 100 mil centers.
JP1 JP1-2 to JP1-60, all even pins on the B side, 100 mil centers.
JP2 JP2-1 to JP2-59, all odd pins on the A side, 100 mil centers.
JP2 JP2-2 to JP2-60, all even pins on the A side, 100 mil centers.
NOTE: The signals at JP1 and JP2 are active when the extender power is on and tri-Stated when the
power is off.
Mechanical Dimensions:
Height 1.6 inches; This dimension is kept less than 2 inches to assure this product is
in compliance with PCI Rev. 2 specifications.
Length 9.6 inches