Teledyne LeCroy Conquest API Manual - API Manual - Manual (Page 35)

ISetting
29
ISetting
This interface sets values of a project. (This is an equivalent to Setting page in Easy (or
Advance) capture project in the software).
When you instantiate the IEsbEasyDataCapturePrj interface, the ISetting interface
instantiates automatically in IEsbEasyDataCapturePrj .
You can get the ISetting interface from IEsbEasyDataCapturePrj by calling
IEsbEasyDataCapturePrj::GetSetting method.
Method Description
SetAnalyzerSpeed Set analyzer speed.
GetAnalyzerSpeed Get analyzer speed.
SetExerciserLoopCounter Set exerciser loop counter.
GetExerciserLoopCounter Get exerciser loop counter.
SetExternalTriggerType Set external trigger type.
GetExternalTriggerType Get external trigger type.
EnableNonStdClock Enable non-standard clock.
IsEnableNonStdClock Is non standard clock enabled?
SetNonStdClockRateType Set non-standard clock rate type.
GetNonStdClockRateType Get non-standard clock rate type.
EnableSecondPort Enable second port.
IsEnableSecondPort Is second port enabled?
SetSecondPortStore Set second port store type.
GetSecondPortStore Get second port store type.
EnableHighSpeedTestMode Enable high-speed test mode.
IsEnableHighSpeedTestMode Is high-speed test mode enabled?
SetInfiniteExerciserLoopCounter Set exerciser loop counter to infinite.
IsInfiniteExerciserLoopCounter Is exerciser loop counter set to infinite?