Setpretrigger, Getpretrigger, Setentirememory – Teledyne LeCroy Conquest API Manual - API Manual User Manual
Page 15: Issetentirememory, Setsamplesno
IusbEasyDataCapturePrj Interface
9
SetPreTrigger
Declaration:
long SetPreTrigger(short sPreTigger)
Input(s):
sPreTigger sets pre-trigger percent. It can be between 1 and 99.
Return Value: Error code or zero (no error)
Remark:
Specifies pre-trigger percent.
Value of this attribute can be between 1 and 99.
See Also
API Errors
GetPreTrigger
Declaration:
short GetPreTrigger()
Input(s):
None
Return Value: Pre-trigger value. It is a short value between 1 and 99.
Remark:
Returns pre-trigger percent setting.
SetEntireMemory
Declaration:
void SetEntireMemory(BOOL bEntireMemory)
Input(s):
bEntireMemory sets entire the memory for capturing.
Output(s)
None
Return Value Error code or zero (no error)
Remark:
If set to TRUE, the system uses entire installed memory.
Otherwise, it uses number specified by SamplesNo.
IsSetEntireMemory
Declaration:
BOOL IsSetEntireMemory()
Input(s):
None
Return Value: Use entire memory flag status.
Remark:
Reports if entire memory flag is set.
SetSamplesNo
Declaration:
long SetSamplesNo(long lSamplesNo)
Input(s):
lSamplesNo specifies the number of samples to capture.
Return Value Error code or zero (no error)
Remark:
Specifies the number of samples to capture.
Note that if EntireMemory property has been set to FALSE, the
system uses this attribute.
See Also
API Errors