Save, Stop, Setanalyzertype – Teledyne LeCroy Conquest API Manual - API Manual User Manual
Page 13: Save run stop setanalyzertype
IusbEasyDataCapturePrj Interface
7
Save
Declaration:
long Save(LPCTSTR strFilePath)
Input(s):
strFilePath points to the fully qualified path to save the file.
Return Value: Zero if the save was successful. Otherwise, non-zero.
Each non-zero value indicates an error code.
Remark:
Saves current easy capture project (.ecp) file.
See Also
API Errors
Run
Declaration:
long Run()
Input(s):
None
Return Value Zero if project can run. Otherwise, non-zero.
Each non-zero value indicates an error code.
Remark:
Checks data entries before run and runs easy data capture project.
See Also
API Errors
Stop
Declaration:
long Stop()
Input(s):
None
Return Value: Zero if project can stop. Otherwise, non-zero.
Each non-zero value indicates an error code.
Remark:
Stops easy data capture project.
See Also
API Errors
SetAnalyzerType
Declaration:
long SetAnalyzerType(short sAnalyzerType)
Input(s):
sAnalyzerType specifies type of analyzer.
Valid analyzer types are introduced in API Constants.
Return Value: Error code or zero (no error)
Remark:
This attribute specifies type of analyzer.
See Also
API Errors