Teledyne LeCroy SAS_SATA Automation API manual - Manual (Page 36)

Teledyne LeCroy SASAnalyzer Object
30 Automation API for Teledyne LeCroy SAS/SATA Protocol Suite
ISASAnalyzer::SetScenarioToPort
HRESULT SetScenarioToPort (
[in] int nBoardIndex
[in]int nPortIndex,
[in] BSTR bstrLibraryName,
[in] BSTR bstrScenarioName,
[out, retval] int* pnErrorCode);
This function assigns a scenario from mentioned library to a specific port of the board.
Parameters
nBoardIndex Zero based index of board. If you have only one board, this
parameter should be set to zero.
nPortIndex Port index that the scenario should assign
bstrLibraryName Specifies the name of the library
bstrScenarioName Name of the scenario that will assigned to the specified port.
pnErrorCode Pointer to an integer which contains an error code if one or
more error(s) has occurred.
Return Values
ANALYZERCOMERROR_UNABLE_TO_START_JAMMER Software is in simulation
mode
ANALYZERCOMERROR_UNABLESTARTRECORDING
Failed to get LeCroy Scenario Manager
Failed to open LeCroy script local file database
Failed to get LeCroy Configure Manager
Failed to create LeCroy script local file database
Failed to load local file scenario
Failed to load local file scenario because invalid scenario
There is no scenario in local file.
Failed to upload the scenario to InFusion device
Failed to upload the scenario to InFusion device
Failed to upload the scenario to InFusion device
Failed to set selected the scenario from InFusion device
Can not find scenario in local file database
Remarks
Before a scenario is started, you must assign it to the available ports using this function.