Teledyne LeCroy DXC100A - Manual (Page 5)

Operator’s Manual
922259-00 Rev A 3
Keep product surfaces clean and dry. Do not submerge probe. Clean with a
water- or alcohol-moistened cloth. Do not use harsh or abrasive cleansers.
Be careful with sharp tips. Tips may cause bodily injury if not handled properly.
Do not operate with suspected failures. Do not use if any part is damaged.
Cease operation immediately and sequester the probe from inadvertent use.
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry
environment. Before using this product, ensure that its operating environment is
maintained within these parameters:
Temperature: Operating, 0° to 50° C; Non-operating, -40° to 71° C
Humidity: ≤ 80% relative humidity (non-condensing).
Altitude: Up to 2000 m (6560 ft).
Introduction
The DXC100A is a high-performance, matched, passive differential probe pair
designed for use with the Teledyne LeCroy DA1855A Differential Amplifiers. The
probe pair consists of two well-matched individual probes sharing a common
compensation box allowing the attenuation factor on both probes to be
simultaneously switched between 10X and 100X. When used with a Teledyne
LeCroy DA1885A Differential Amplifier, the probe’s attenuation factor is
automatically incorporated into the effective gain display and the decimal
properly located in the Precision Voltage Generator (PVG) display.
Although primarily designed for use with Teledyne LeCroy amplifiers, the
DXC100A can be used with any oscilloscope or plug-in unit with an input
impedance of 1 MΩ/15-26pF and one inch (25.4 mm) spacing between
connectors.