Teledyne LeCroy DXC100A - Manual (Page 21)

Operator’s Manual
922259-00 Rev A 19
Australia & New Zealand Declaration of Conformity
—EMC
Probe complies with the EMC provision of the Radio Communications Act per
the following standards, in accordance with requirements imposed by Australian
Communication and Media Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in
accordance with EN61326-1:2006 and EN61326-2-1:2006.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC Declaration of Conformity
– Low Voltage
The probe meets intent of EC Directive 2006/95/EC for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements for
hand-held probe assemblies for electrical measurement and test.
Environmental Compliance
End-Of-Life Handling
The instrument is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations that
vary by country and region. Many countries prohibit the disposal of waste
electronic equipment in standard waste receptacles. For more information
about proper disposal and recycling of your Teledyne LeCroy product, please
visit teledynelecroy.com/recycle.
Restriction of Hazardous Substances (RoHS)
This instrument has been classified as Industrial Monitoring and Control
Equipment and is outside the scope of the 2011/65/EU RoHS Directive until 22
July 2017 (per Article 4, Paragraph 3).