Teledyne LeCroy HDO 4000 Getting Started Guide - Manual (Page 36)

923010-00 Rev A
BASICS 32
Measurements & Statistics
Measurements are waveform parameters that can be expressed as numerical values, such as amplitude or frequency. You can set up-to-eight
simultaneous measurements on one or more channel traces and view the active readout in a table. Statistical measurements can be added to the
table of parameter values. You can also view measurements as a histicon, a miniature histogram, or open a second grid showing the trend, a plot of
the values showing how the measurement has changed over time. Levels can be set for certain parameters that required them. Measurements gates
can be used to only perform measurements on a specific portion of the waveform.
Choose Measure > Measure Setup to open the
Measure dialog.
Touch to re-open Measure dialog.
Statistics can be added to the readout.
Readout of parameter values.
Touch to show table of parameter values.
Touch to choose parameter.
Touch to choose source channel.
Touch to display trend.
Touch to set a level(s) used for @level
parameters.
Touch to set measurement gates.
Select to display histicons.
Select to display statistics.
A
B
C D
E
F G
A
B
C
D
E
F
G
H
I
H
I
J
J
K
L
K
L