Teledyne LeCroy HDO 4000 Getting Started Guide - Manual (Page 30)

923010-00 Rev A
BASICS 26
Choose a standard
Logic Family, or enter
custom values for
Threshold
and Hysteresis.
Separate controls allow
you to set different
values for each bank.
Digital Traces From the Display
Touch to activate the digital trace and
again to open the Digital dialog.
Transitioning High Low
Line Activity Indicators
Line trace shows high, low and transition points for each line.
Bus trace collapses lines into hex values.
Touch tab to choose digital group (1-4).
Choose to display individual digital lines, bus trace or both.
Touch arrows to switch between banks 0-7 and 8-15.
Touch checkbox to select the lines in the group.
Enter Vertical Position (top of lowest bit relative to center) and Group
Height (vertical space occupied by group) in divisions.
Watch Line Activity Indicators instead of line traces to quickly see the
state of each digital line.
Touch to open Logic Setup dialog.
A
B
C
D
E
F
G
A
B
C D
E
F
G