Teledyne LeCroy USB2-GPIB - Manual (Page 11)

9 923571-00 Rev A
Certifications
EMC Compliance
EC DECLARATION OF CONFORMITY - EMC
The converter meets intent of EC Directive 2004/108/EC for Electromagnetic Compatibility.
Compliance was demonstrated to the following specifications as listed in the Official
Journal of the European Communities:
EN 61326‐1:2006, EN 61326‐2‐1:2006 EMC requirements for electrical equipment for
measurement, control, and laboratory use.
European Contact:
Teledyne LeCroy Europe, GmbH
Waldhofer Str 104
D‐69123 Hidelberg, Germany
Tel: (49) 6221 82700
AUSTRALIA & NEW ZEALAND DECLARATION OF CONFORMITY - EMC
The converter complies with the EMC provision of the Radio Communications Act
per the following standards, in accordance with requirements imposed by Australian
Communication and Media Authority (ACMA):
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with
EN61326‐1:2006 and EN61326‐2‐1:2006.
Australia / New Zealand Contacts:
Safety Compliance
EC DECLARATION OF CONFORMITY - LOW VOLTAGE
The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010‐1:2010 Safety requirements for electrical equipment for measurement, control,
and laboratory use – Part 1: General requirements
EN 61010‐031/A1:2008 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 031: Safety requirements for hand‐held probe assemblies
for electrical measurement and test.
Environmental Compliance
END-OF-LIFE HANDLING
The converter is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The converter is subject to disposal and recycling regulations that
vary by country and region. Many countries prohibit the disposal of
waste electronic equipment in standard waste receptacles. For more
information about proper disposal and recycling of your Teledyne
LeCroy product, please visit teledynelecroy.com/recycle.
RESTRICTION OF HAZARDOUS SUBSTANCES (RoHS)
The converter conforms to 2011/65/EU RoHS2 Directive based on the fact that it is
classified as Industrial Monitoring and Control Instrument (per Article 3, Paragraph 24) and
these product(s) & associated accessories are exempt from RoHS compliance until 22 July
2017 (per Article 4, Paragraph 3) .
VICOM
1064 Centre Road
Oakleigh, South Victoria 3167
Australia
VICOM New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand