Steelcraft Automotive 83080 REAR BUMPER GUARD - Manual

PARTS LIST:
1 Rear Bumper Guard
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL
PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING
INSTALLATION.
2. IMPORTANT! Due to the passenger side mounting
location being too close to the muffler, before
starting the installation make sure the muffler is not
hot. From underside of vehicle, locate the three
factory bolts and one factory nut at the end of each
chassis. Remove the two rear factory bolts (closest
to the factory nut) at each end of chassis (Figure 1).
3. With help position Rear Bumper Guard to the
previously removed factory bolt locations. Attach
Rear Bumper Guard to the chassis using the factory
bolts. Do not tighten at this time (Figure 2).
4. Adjust Rear bumper Guard properly; and then
tighten all hardware at this time.
5. Do periodic inspections to the installation to make
sure that all hardware is secure and tight.
To protect your investment, wax this product after
installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of
polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to
polish small scratches and scuffs on the finish. Mild soap
may be used also to clean the Rear Bumper Guard.
Page 1 of 2 11/27/07
(AM)
INSTALLATION INSTRUCTIONS
REAR BUMPER GUARD (Double Tube)
01-07 TOYOTA SEQUOIA
PART #
Fig 1
Fig 2