Steelcraft Automotive 32020 TAILLIGHT GUARD User Manual
Installation instructions
PARTS LIST:
1 Driver/Left Taillight Guard
6 ST4 x 20mm Sheet Metal Screws
1 Passenger/Driver Taillight Guard
6 4mm ID x 9mm OD x 1mm Flat Washers
PROCEDURE:
1.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2.
Open the tailgate and position the driver Taillight Guard over taillight housing. Center and align the Taillight
Guard; then use the holes on the mounting tabs as a template to mark the drilling location on the vehicle
(Figure 1).
3. Remove the Taillight Guard and set aside.
4.
Center punch the marked locations, then use a 1/8” drill bit to drill the marked locations (Figure 2).
IMPORTANT: Any cutting tool may break or shatter. Government regulations require safety glasses &
equipment at all times when drilling.
5. Reposition the Taillight Guard back onto the taillight housing. Align the previously drilled holes with holes on
the mounting tabs.
6.
Attach Taillight Guard to vehicle using the included (3) ST4 x 20mm Sheet Metal Screws and (3) 6mm Flat
Washers (Figure 3). Tighten screws all the way. NOTE: Do not over tighten screws or a pull out may occur.
7.
Repeat steps 2-6 for passenger side Taillight Guard.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective
layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may
be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
(Driver Side Installation Shown)
Page 1 of 2
10/15/07
(AM)
INSTALLATION INSTRUCTIONS
TAILLIGHT GUARD
94-01 DODGE RAM 1500 / 94-02 DODGE RAM 2500/3500
PART # 32020
Mark drilling
location
- ST4 x 20mm
Sheet Metal
Screws
- 4mm Flat
Washers
Installation Complete