Steelcraft Automotive 33300 TAILLIGHT GUARD - Manual

INSTALLATION INSTRUCTIONS
TAILIGHT GUARD #33300
2007 TOYOTA FJ-CRUISER
PARTS LIST:
(1) TAILIGHT GUARD - DRIVER SIDE
(1) TAILIGHT GUARD – PASSENGER SIDE
(2) END BRACKETS
(2) #6 X 1/2 SHEET METAL SCREWS PHIL PAN HEAD
(3) #8 X 3/4 SELF TAP PHIL HEAD SCREW
PROCEDURE:
1- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY.
2- TEMPORARILY REMOVE EXISTING SUB WOOFER LOCATED ON
PASSENGER SIDE AND SET ASIDE. SEE FIG. #1.
3- LOCATE AND REMOVE PLASTIC SIDE PANEL. LOOSEN HEX NUTS
BEHIND TAIL LIGHT ON PASSENGER SIDE. SEE FIG #2
4- LOOSEN THIRD HEX NUT THROUGH THE LARGE INTERIOR SIDE
PANEL OPENING THAT IS EXPOSED AFTER REMOVING THE SUB
WOOFER. SEE FIG. #3
5- PULL OUT TAILIGHT GUARD UNTIL YOU HEAR THE TAILIGHT POP
OUT. INSERT (1) END BRACKET IN BETWEEN TAILIGHT AND BODY OF
VEHICLE ADJUST AND PUSH TAILIGHT GUARD BACK IN. PASSENGER
SIDE SHOWN. SEE FIG. #4.
6- HAND TIGHT THIRD HEX NUT FOR SNUG FIT. SEE FIG. #3
7- REMOVE DOOR STRIKER LOCATED ON PASSENGER SIDE AND
INSTALL PASSENGER TAIL LIGHT GUARD. LEAVE LOOSE. SEE FIG. #5
8- ATTACH END BRACKET TO TAILIGHT GUARD USING (1) #6 X 1/2
SHEET METAL SCREW PHIL PAN HEAD. LEVEL AND ADJUST
TAILIGHT GUARD AS DESIRED. TIGHTEN AND TORQUE DOOR
STRIKER BOLTS.
9- REPEAT PROCEDURES #3, 4, 5, AND 6 ON DRIVER SIDE.
10- INSERT DRIVER SIDE TAILIGHT GUARD BETWEEN DOOR AND INNER
BODY WALL. ADJUST AND PREMARK HOLES AS DESIRED. SEE FIG. #6
11- PREDRILL HOLES WITH SIZE 33 DRILLBIT(#2). INSTALL TAILIGHT
GUARD USING (3) #8 X 3/4 SELF TAPING SCREWS (INNER BODY WALL)
AND (1) #6 X 1/2 SHEET METAL SCREW PHIL PAN HEAD (END
BRACKET) LEVEL AND ADJUST THEN TIGHTEN. SEE FIG. #7.
12- RE INSTAL DRIVER AND PASSENGER SIDE PANELS AND SUB
WOOFER.