beautypg.com

Steelcraft Automotive 33010 TAILLIGHT GUARD User Manual

Steelcraft Automotive For the car

background image

TAILLIGHT GUARD

96-02 TOYOTA 4RUNNER

Page 1 of 1 Rev 1 (DP) 7/24/12

PARTS LIST:

1 Driver/Left Taillight Guard

1 Passenger/Right Taillight Guard

4 6-1.00mm x 25mm Phillips Screws

4 6mm x 12mm OD x 1.5mm Flat Washer










PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS

CAREFULLY BEFORE STARTING INSTALLATION.

2. Open the rear door and remove driver side factory screws holding the passenger side taillight assembly

into the body panel, (Figure 1). NOTE: Taillight assembly removal not required for installation.

3. Carefully position the passenger side Taillight Guard over the taillight assembly and attach it using the

included (2) 6mm x 25mm Phillips Screws and (2) 6mm Flat Washers, (Figures 2 & 3). NOTE: The
long Mounting Brackets on the Taillight Guard can be adjusted for alignment as required. Re-bend the
brackets as necessary for proper fit and clearance as pictured above.

4. Once the Taillight Guard is fully installed, slowly close the rear door and check for clearance.

IMPORTANT: Do not close the rear door without checking for clearance first.

5. Repeat Steps 2 - 4 for driver side Taillight Guard installation.
6.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.


To protect your investment
, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel
: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Taillight Guard.
For gloss black finishes: Mild soap may be used to clean the Taillight Guard.
















Fig 1

Fig 2

Fig 3