Steelcraft Automotive 33250 TAILLIGHT GUARD - Manual (Page 3)

TAILLIGHT GUARD
2005-13 TOYOTA TACOMA
Page 3 of 3 Rev 1 (DP) 8/28/13
Driver Side Installation Pictured
(Fig 5) Use both hands (one on bottom, one on top)
to hold the Taillight Guard in place over the taillight.
Slide the taillight and Guard into the opening in the
rear fender
(Fig 6) Once the tabs are lined up with the
mounting holes, push only the taillight assembly
into place until the mounting pins "pop." DO
NOT PUSH the taillight assembly all of the way
in until the tabs on the Taillight Guard are lined
up with the mounting holes
(Fig 7) Reuse the (2) factory hex bolts to
attach the Taillight Guard to the vehicle
(Fig 4A) Small tab hooked onto the outer edge of
the taillight assembly (back of taillight assembly
pictured from above)
Taillight
Guard