beautypg.com

Steelcraft Automotive 440710 4 OVAL SIDE BAR User Manual

Steelcraft Automotive For the car

background image

4

” OVAL STRAIGHT SIDEBAR

04-12 NISSAN TITAN KING CAB

Page 1 of 3

03/26/12 Rev 1 (DP)


PARTS LIST:

1 Driver/Left Sidebar

12 8-1.25mm x 25mm Hex Bolts

1 Passenger/Right Sidebar

18 8mm Lock Washers

3 Driver/Left Mounting Brackets

18 8mm x 24mm OD x 2mm STD Flat Washers

3 Passenger/Right Mounting Brackets

6 8mm x 16mm OD x 1.6mm Small Flat Washers

6 8-1.25mm x 30mm Hex Bolts

6 8mm Nylon Lock Nuts


























PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Start installation at the front of the driver side of the vehicle and locate the factory threaded

stud and the threaded hole located on the side of the inner body panel, (Figure 1). NOTE:
Remove the plastic plug or any insulation on the side panel to locate the threaded holes.

3. Select (1) driver side Mounting Bracket. Attach the Bracket to the threaded stud with (1) 8mm x

24mm STD Flat Washer and (1) 8mm Nylon Lock Nut. Next, insert (1) 8mm x 30mm Hex Bolt
with (1) 8mm Lock Washer and (1) 8mm x 16mm Small Flat Washer through the remaining
lower hole in the Bracket and into the threaded hole, (Figure 2). Snug but do not tighten
hardware at this time.

Driver/Left Side
Mounting Brackets

Passenger/Right Side
Mounting Brackets

Front of

Vehicle

Front of

Vehicle

Insert locations
for brackets

Front of

Vehicle