beautypg.com

Steelcraft Automotive 232300 3 ROUND SIDE BAR User Manual

Steelcraft Automotive For the car

background image

Page 1 of 2

Installation Instructions

Side Bar P/N:

Vehicle: 2004-06 Toyota Tundra D-Cab

Part List:

Q’ty Description Q’ty Description

1 Passenger Side Bar 1 Driver Side Bar

2 Front Mounting Bracket 2 Rear Mounting Bracket

1 Bolt Plate-Driver Side/Large 1 Bolt Plate- Passenger Side

4 3” Plastic Rings, Black 6 1/2”-13X2.00” Hex Head Bolt

8 1/2” Flat Washers 8 1/2” Lock Washers

4 1/2-13 Hex Nuts 2 Spacer Washers (1.88” O.D.)


(Note: Passenger Side Tube is packed in the pink sleeve and Driver Side Tube is packed in clear sleeve)

Product installation:

1. Verify that all parts & Hardware are present. Read instruction completely before

installing.


2. Locate the rectangular holes in frame towards the front of the vehicle. Insert bolt

plates into the hole from the inside of frame.



3. Attach rear brackets as shown, place behind body mount. Hand tighten. Note:

place the spacer washer under the head of the hex head bolt and insert through
frame from the inside of frame.


4. Place the side bars into position and attach tubes using (1) 1/2”-13*20” hex head

bolt, (1) 1/2” flat washer,(1) lock washer per bracket. Make sure the 3” plastic
ring is attached at each end of tube.



5. Verify that the side bars are level and square with side of the vehicle and then

completely tighten all hardware.


6. Periodically check and retighten the hardware as necessary.
*Be sure to use all hardware supplied and tighten bolts.