Steelcraft Automotive 221120 3 ROUND SIDE BAR - Manual (Page 2)

3" SIDEBARS
2011-13 DODGE DURANGO
Page 2 of 3 10/23/12 (DP)
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean Sidebar.
Driver Side Installation Pictured
(Fig 1) Driver side pictured
from below vehicle
(Fig 2B) Driver side pictured
Remove rubber plug
Front To determine the correct mounting
location, locate the three pairs of (2)
factory holes in the pinch weld and
the rubber plug in the floor panel
(Fig 2A) 12mm x 40mm
Bolt Plate
Insert Bolt Plates then
rotate 90-degrees to the
slot or until it stops for
proper installation
(Fig 3) Thread Plastic Retainer onto Bolt Plate
Outside