Steelcraft Automotive 214000 3 ROUND SIDE BAR - Manual

3" SIDEBARS
2013 FORD ESCAPE
Page 1 of 7 9/26/12 (DP)
PARTS LIST: -
Qty Description Qty Description
1 Driver / Left Sidebar 2 12mm Plastic Retainers
1 Passenger / Right Sidebar 8 10mm Plastic Retainers
1 Driver / Left Front Mounting Bracket 2 12mm x 32mm OD x 3mm Flat Washers
1 Passenger / Right Front Mounting Bracket 2 12mm Lock Washers
1 Driver / Left Center Mounting Bracket 2 12mm Hex Nuts
1 Passenger / Right Center Mounting Bracket 8 10mm x 27mm OD x 3mm Flat Washers
1 Driver / Left Rear Mounting Bracket 8 10mm Lock Washers
1 Passenger / Right Rear Mounting Bracket 8 10mm Hex Nuts
2 12mm x 35mm Special Bolt Plate (Rear) 12 8-1.25mm x 30mm Hex Bolts
5 10mm x 30mm Button Head Bolt Plates 12 8mm x 24mm OD x 2mm Flat Washers
2 10mm x 30mm T-Bolts (Both Front Outer) 12 8mm Lock Washers
1
10mm x 35mm Small T-Bolts (Driver Front Inner
only)
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. ASSISTANCE IS
RECOMMENDED.
2. Start installation under the driver side of the vehicle. NOTE: To help determine the correct mounting
holes to use, hold the front Bracket up in position against the floor panel and line up the Bracket with
the correct holes, (Fig. 1).
a. Driver side front Bracket installation:
Select (1) 10mm x 30mm Small T-Bolt and (1) 10mm Plastic Retainer, (Fig. 2A). Partially thread
the Retainer onto the T-Bolt. Insert the T-Bolt into the inner factory oval hole, (Fig. 1 & 3). Rotate
Driver/Left Rear
Mounting Bracket
Driver/Left Front
Mounting Bracket
Driver/Left
Center Bracket
Passenger/Right
Rear Mounting
Bracket
Passenger/Right
Center Bracket
Passenger/Right Front
Mounting Bracket
(2) 12mm x 35mm Bolt Plate
(Rear Brackets)
(5) 10mm x 30mm Bolt Plates
(2) 10mm x 35mm Small T-Bolt
(Driver Front Bracket Only)
(2) 10mm x 30mm Large T-Bolt
(Outer Front Brackets)
Driver/Left Sidebar
Passenger/Right Sidebar
Front