Steelcraft Automotive 170300 RUNNING BOARD - Manual

ALUMINUM VIEWPOINT RUNNING BOARDS
2011-12 HYUNDAI SANTA FE
Page 1 of 5 10/19/12(DP)
(4) 12mm x 35mm
Hex Bolt Plates
(6) 12mm x 35mm Low
Profile Bolt Plate
PARTS LIST:
1 Driver Side Running Board 4 12-1.75mm x 35mm Large Bolt Plates
1 Passenger Side Running Board 10 12mm Plastic Retainers
2 Front Bracket Arms 10 12mm x 32mm OD x 3mm Flat Washers
2 Front Inner Mounting Brackets 10 12mm Lock Washers
1 Passenger Side Front Outer Mounting Bracket 10 12mm Hex Nuts
1 Driver Side Front Outer Mounting Bracket 16 8mm x 25mm Hex Bolts
2 Center Bracket Arms 32 8mm x 22mm x 2mm Flat Washers
2 Center Mounting Bracket 16 8mm Lock Washers
1 Driver Side Rear Bracket Arm 16 8mm Hex Nuts
1 Passenger Side Rear Bracket Arm 12 6mm T-Bolts
1 Driver Side Rear Mounting Bracket 12 6mm x 22mm x 2mm Flat Washers
1 Passenger Side Rear Mounting Bracket 12 6mm Lock Washers
6 12-1.75mm x 35mm Low Profile Bolt Plates 12 6mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the front, passenger side of the vehicle, remove the plug in the back of the body panel above
the pinch weld and the rubber plug in the bottom of the inner frame channel, (Figures 1B & 2B).
IMPORTANT: Plugs may be covered with sealant or undercoating. Brackets must fit flush against sheet
metal. Scrape of any excess sealant or undercoating. Repeat this Step for all mounting locations.
Passenger/Right Rear
Mounting Bracket
Passenger/Right Rear
Mounting Bracket Arm
(2) Center Mounting Brackets
(2) Center Bracket Arms
Passenger/Right Front Outer
Mounting Bracket
(2) Front Bracket Arms
(2) Front Inner
Mounting Brackets
Driver/Left Front Outer
Mounting Bracket
Driver/Left Rear
Mounting Bracket Arm
Driver/Left Rear
Mounting Bracket
Passenger/Right Running Board
Driver/Left Running Board
Front