Steelcraft Automotive 72190 SPORT BAR - Manual

PARTS LIST:
1 Grille Guard 4 12-1.75mm x 30mm Hex Head Bolts
1 Passenger Side Mounting Bracket (D) 4 12mm Nylock Nuts
1 Driver Side Mounting Bracket (A) 4 12mm Lock Washers
1 Passenger Side Double Nut Plate (C) 4 12-1.75mm x 35mm Hex Head Bolts
1 Driver Side Double Nut Plate (B) 12 12mm ID x 30mm OD x 3mm Flat
Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. From underside of vehicle, remove the passenger and driver side rubber shroud located by the
bumper air inlet (Figure 1).
3. Through bumper air inlet, insert passenger side Double Nut Plate through existing hole on the
radiator support (Figure 2). NOTE: Use the larger round hole on the radiator support to insert
Double Nut Plate.
4. Center holes on the Double Nut Plate with holes on the radiator support.
5. Hang passenger side Mounting Bracket into position by partially treading (1) 10-1.50mm x 35mm
Hex Head Bolt, (1) 10mm Flat Washer, and (1) 10mm Lock Washer on the inner side of the
Mounting Bracket and trough already inserted Double Nut Plate (Figure 3). From underside of
vehicle proceed to install another Bolt with Washer and Lock Washer on the outer side of the
Mounting Bracket and trough Double Nut Plate. Do not tighten at this time.
6. Repeat steps 3-5 for driver side.
7. Position Sport Bar on the outer side of Mounting Brackets. Install Sport Bar onto Mounting
Brackets using the included (4) 12-1.75mm x 30mm Hex Head Bolts, (4) 12mm Nylock Nuts, and
(8) 12mm Flat Washers (Figure 4). Do not tighten at this time.
8. Level and adjust Sport Bar as desired; then tighten all hardware at this time.
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Page 1 of 2
2/12/07 (AM)
INSTALLATION INSTRUCTIONS
SPORT BAR
08 JEEP LIBERTY
PART #72190S
Remove this
plastic shroud
Bottom side
of radiator
(A) (D)
(B) (C)