Steelcraft Automotive 75010 BULL BAR User Manual
Installation instructions

PARTS LIST:
Qty
Description
Qty
Description
2
Frame Brackets
8
12mm Washers
4
12*30mm Hex Bolts
4
12mm Hex Nuts
4
12mm Lock Washers
PROCEDURE:
1.
Remove push type retainers from lower splash shield. Remove plastic splash
shield to access to mounting location.
2. Locate and remove bolts that hold the frame brace and bumper brackets to
vehicle.
3. Install frame bracket between lower radiator support and frame brace using (3)
existing bolts. As shown.
4. Cut plastic splash shield to allow brackets to pass through. See Cutting Instruction
sheet for guidelines on cutting. Reinstall plastic splash shield over brackets in this
same order removed.
5. Position the bull bar assembly to the lower frame brackets (outer side) using
12*30mm hex bolts,12mm hex nuts and12mm washers.
6. Align the bull bar assembly with the front of the vehicle and tighten all
fasteners.
DRIVER SIDE SHOWN
LOWER RADIATOR
SUPPORT
FRAME SUPPORT
EXISTING BOLTS
INSTALLATION INSTRUCTIONS
BULL BAR
2006-10 HONDA RIDGELINE PART# 75010 / 75010B
Pictures are only for
reference.