Staub Electronics EA-MINI-2D-35 EPISODE - 2 CHANNEL 35 WATTS DIGITAL MINI-AMPLIFIER - Manual (Page 16)

EA-MINI-XD-35 Installation Manual
Pg. 16
© 2013 Episode ®
13. Troubleshooting
No audio
• Power cable to the amplifier is incorrectly connected or plugged into
an outlet that does not have power. Check connections and verify
power on the outlet.
• Audio cable to the source component is not connected properly, is
connected to the incorrect input, or the cable is defective.
• Set the input volume level higher.
• Check audio output of source for correct setup.
• Check the speaker connections and wiring for proper setup.
Hum or buzzing sound is
heard
• Check RCA input cables by removing them one at time (powering
down the amplifier before disconnecting) and checking to see if a
connection or cable is to blame.
Amplifier will not turn on
• The amplifier must be plugged into a live outlet.
• The power switch on the back panel must be on.
Amplifier will not turn on or
switch inputs automatically.
• Auto-On is automatically disabled when discrete or toggle power
commands are used. Power cycle the amplifier to reset Auto-On
and set the amplifier up to use only Auto-On or only IR power
commands.
• Auto-On can be disabled by switching it off using a custom IR
command. Toggle the setting back to On.
• Auto-Input is disabled when inputs are changed manually until the
system is shut down and powered back on.
• Auto-Input can be disabled by switching it off using a custom IR
command. Toggle the setting back to On.
Low frequencies are not
playing properly through the
speakers.
• Set dip switch 4 UP to FULL to allow full frequency audio through
the normal speakers.