Staub Electronics EA-MINI-2D-35 EPISODE - 2 CHANNEL 35 WATTS DIGITAL MINI-AMPLIFIER - Manual (Page 10)

EA-MINI-XD-35 Installation Manual
Pg. 10
© 2013 Episode ®
9. Speaker Connections and Setup
9.1.1. Stereo/Mono Dip Switch (Switch 3)
9.1.2. Analog RCA Subwoofer Output
9.1.3. Speaker Wire Terminiation
Position Output Mode Descrpition
Up Mono All speakers play the same mixed audio
Down Stereo Each speaker plays its own audio channel
Set the output from the speakers to be mono or stereo format. Use mono for applications where left and right
can’t be balanced. Use stereo to provide the most accurate recreation of audio for movies and television.
Connect an RCA cable between the amplifier’s SUB OUT port and a powered subwoofer or subwoofer
amplifier. Use the crossover cutoff in the subwoofer amplifier to set the frequency range.
Note: The subwoofer output volume may be controlled independently by using the EA-MINI-RC accessory
remote, or by using commands from the IR protocol. Visit the product page for the EA-MINI-XD-35 at
www.snapav.com for these items.
1. Strip the outer jacket (if applicable) of the speaker cable back about 2”, and then strip the insulation of
each wire back ¼“.
2. Loosen the set screws on the connector using a 1/8” flat blade screwdriver.
3. Twist the wires clockwise, insert them into the correct holes per the diagram on the amplifier, and tighten
the screws. Do not allow any strands of copper to touch between the terminals to avoid short circuits. 5 INPUT PRIORITY 1/2
R+ R- L+ L-
DIGITAL IN
SUB OUT ANALOG IN
RIGHT
1 2 3 4 5 IR IN
IR OUT
+5V GND
RESET
SWITCH ASSIGN UP/DOWN 1
2
3
4
IR RECEIVE/CONTROL
RUN/LEARN
STEREO/MONO
HIGH PASS 60Hz/FULL
SPEAKER OUTPUTS
STATUS
1
2
LEFT
SWITCHES
100-240V~50/60Hz 1.6A
Left
Speaker
L+ L-
Right
Speaker
R+ R-
EA-MINI-2D-35 EA-MINI-3D-35
Center
Speaker
C+ C-
Left
Speaker
L+ L-
Right
Speaker
R+ R-
1 2 3 4 5
SWITCHES
1 2 3 4 5
SWITCHES