Staub Electronics EA-MINI-2D-35 EPISODE - 2 CHANNEL 35 WATTS DIGITAL MINI-AMPLIFIER - Manual (Page 12)

EA-MINI-XD-35 Installation Manual
Pg. 12
© 2013 Episode ®
11. IR Connections and Setup
11.1. IR Connections and Controls
11.2. IR Control Options
IR In Port
Connect an IR Receiver or a 3.5mm mono mini cable to this port to input IR commands for amplifier control.
Be sure to set the IR Receive/Control dip switch correctly to configure the port for the desired pinout.
IR Receive/Control Dip Switch
Controls the pinout of the IR In port to provide power for an IR Receiver if needed. The pinout of each setting
is described below:
IR Out Port
The IR Out port repeats all commands received from the IR In port. Connect IR
flashers to this port for control of other equipment.
If more flashers are required, connect the port to an IR distribution block to power
additional flashers.
The optional accessory remote (EA-MINI-RC) is designed to include
most functions necessary for setup. It may also be used for regular
control.
For more information please visit the EA-MINI-RC product page at
www.SnapAV.com.
11.2.1. Optional Accessory Remote (EA-MINI-RC)
IR Receiver
IR Signal (Tip)
GND (Ring)
12V DC (Sleeve)
1 2 3 4 5
SWITCHES
1 2 3 4 5
SWITCHES
Switch1 Down
Control
IR Signal (Tip)
GND (Ring)
1 2 3 4 5
SWITCHES
1 2 3 4 5
SWITCHES
Switch1 Up
IR Signal (Tip)
GND (Ring)