Arcam FMJ AVR600 - Manual (Page 58)

E-56
Continuous power output (20Hz—20kHz at 0.05% THD), per channel
2 channels driven
150W
All channels driven 120W
THD at full rated power <0.2%
Residual noise & hum <0.25mV unweighted 20Hz – 22kHz
Inputs
Phono input:
Input sensitivity at 1kHz
5mV
Input impedance 47k Ω
Signal/noise ratio (CCIR, 65W) 88dB
Overload margin 31dB
Line inputs:
Nominal sensitivity
500mV–4V (user adjustable)
Input impedance 47k Ω
Signal/noise ratio (CCIR, 65W) 100dB
Preamplifier outputs
Max output level
6V RMS
Output impedance <50 Ω
THD+N (20Hz—20kHz) -100dB
Video inputs
Component video signal/noise
85dB
Composite video signal/noise 70dB
Headphone output
Maximum output level into 600
Ω 4V p-p
Output impedance <5 Ω
General
Mains voltage
110–120V or 220–240V
Power consumption (maximum) 1.5kVA (Thermal dissipation approx. 2300 BTU/hour)
Power consumption (idle, typical) 120VA (Thermal dissipation approx. 410 BTU/hour)
Power consumption (standby) 3VA
Dimensions W x D x H (including feet) 432 x 450 x 180mm
Weight (net) 25.0kg
Weight (packed) 28.0kg
Supplied accessories Mains lead
CR102 remote control
4 x AAA batteries
Manual
HDMI lead support bar
DAB aerial (if DAB module fitted)
FM aerial
AM loop aerial
Calibration microphone
E&OE
NOTE: All specification values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.
specifications